Table of Contents
Advertisement
Important:
Do not run the starter motor
more than 30 seconds at a time or premature
starter failure may result. If the engine fails
to start after 30 seconds, turn the key to
the O
position, check the controls and
FF
procedures, wait 30 additional seconds, and
repeat the starting procedure.
5.
Allow the engine to warm up at mid speed
(without load), then move the throttle control to
the desired position.
Important:
Allow the engine to idle for 5 minutes
before shutting it off after a full-load operation.
Failure to do so may damage the turbocharger.
Using Cruise Control
The cruise-control switch locks in the pedal position to
maintain the desired ground speed. Pressing the rear
of the switch turns the cruise control off, the middle
position of the switch enables the cruise-control
function, and the front of the switch sets the desired
ground speed.
Note:
Pressing either the brake pedal or moving the
traction pedal into the R
also disengages the pedal position.
Shutting Off the Engine
Important:
Allow the engine to idle for 5 minutes
before shutting it off after a full-load operation.
This allows the turbocharger to cool down before
shutting off the engine. Failure to do so may lead
to turbocharger trouble.
Note:
Lower the mower decks to the ground
whenever machine is parked. This relieves the
hydraulic load from the system, prevents wear on
system parts, and also prevents accidental lowering
of the mower decks.
1.
Move the throttle control backward to the S
position.
2.
Move the PTO switch to the O
3.
Engage the parking brake.
4.
Rotate the ignition key to the O
5.
Remove the key from the switch to prevent
accidental starting.
Using the Engine-Speed
Switch
The engine-speed switch has 2 modes to change the
engine speed. By momentarily tapping the switch,
the engine speed increases or decreases in 100-rpm
position, for 1 second,
EVERSE
position.
FF
position.
FF
increments. By holding the switch down, the engine
automatically moves to H
on which part of the switch you pressed.
Adjusting the Mowing
Speed
Supervisor (Protected Menu)
This feature allows the supervisor to set the maximum
mowing speed in increments of 5% between 30 and
100%, at which the operator can mow (low range).
Refer to
Setting the Maximum Allowed Mow Speed
(page 36)
for the procedure to set the mow speed.
Operator
This feature allows the operator to adjust the
maximum mowing speed (low range), within the
supervisors pre-adjusted settings. When in the
InfoCenter splash or main screen, press the middle
button (
icon) to adjust the speed.
Note:
When switching between low and high ranges,
the settings will transfer based on the previous setting.
The settings are reset when the machine is turned off.
Note:
This feature may also be used in conjunction
with cruise control.
Adjusting the Transport
Speed
Supervisor (Protected Menu)
This feature allows the supervisor to set the maximum
transport speed in increments of 5% between 30
and 100%, at which the operator can transport (high
range).
Refer to
Setting the Maximum Allowed Transport
LOW
Speed (page 36)
speed.
Operator
This feature allows the operator to adjust the
maximum transport speed (high range) within the
supervisor's pre-adjusted settings. When in the
InfoCenter splash or main screen, press the middle
button (
icon) to adjust the speed.
Note:
When switching between low and high ranges,
the settings transfer based on the previous setting.
The settings are reset when the machine is turned off.
Note:
You can also use this feature in conjunction
with cruise control.
40
or L
IGH
OW IDLE
for the procedure to set the transport
, depending
Advertisement
Table of Contents
