Table of Contents
Advertisement
1.
Be sure that thermal pads are installed on the system board underneath the memory modules.
2.
Align the notched edge of the module with the tab in the slot (1), and then press the module into the
slot at an angle until it is seated (2).
3.
Press down on the module until the side retention clips snap into place (3).
WLAN module
To remove the WLAN module, use this procedure and illustration.
Table 5-5
WLAN module descriptions and part numbers
Description
Intel Wi-Fi 7 BE200 + Bluetooth 5.4 WLAN, non-vPro
36
Chapter 5 Removal and replacement procedures for authorized service provider parts
Spare part number
N39883-005
Advertisement
Table of Contents
