Wifi Module (Wifi1), Network Board - Sony MAP-S1 Service Manual

2-22. WiFi MODULE (WIFI1), NETWORK BOARD

Note 1: When the WiFi module (Ref. No. WIFI1) is replaced, refer to
"NOTE OF REPLACING THE WiFi MODULE", "PROCESS-
ING OF REPLACING THE WiFi MODULE" and "CHECKING
METHOD OF NETWORK CONNECTION" on page 6.
cushion
(POWER B)
guide line
flexible flat cable
(31P)
Note 2: Insert the connector straight into the interior.
There is a possibility that using this device without
the connector correctly installed will damage it.
Insert straight into
Insert only part way.
the interior.
connector
connector
connector connector
2 two screws
(BV3)
4 WiFi module
(WIFI1)
0 NETWORK
board
1 connector
(CN3009)
3 connector
8 flexible flat cable (31P)
(CN3010)
Insert at a slant.
connector
connector
5 two screws
(BVTP3 8)
6 cover
(PWB NET)
9 gasket
(LAN)
(CN3001)
7 braket
PWB NET
Note 3: When installing the flexible flat cable, ensure that
the colored line is parallel to the connector after insertion.
Insert straight into the interior.
flexible flat
cable
colored line
connector
MAP-S1
5 two screws
(BV/ring)
J3001 guide line
NETWORK
gasket (LAN)
board
Insert at a slant.
flexible flat
cable
colored line
connector
27