Amp Board Block - Sony MAP-S1 Service Manual

2-24. AMP BOARD BLOCK

Note 1: When installing the AMP board block,
Wire e i
flexible flat cable
(9P)
Wire passes along the bottom of
flexible flat cable (9P).
Note 2: Insert the connector straight into the interior.
There is a possibility that using this device
without the connector correctly installed will
damage it.
OK
Insert straight into
the interior.
connector
connector
NG
Insert only part way.
connector
connector
check that two claws are attached firmly.
OK NG
AMP board
MAIN board
Note 3: When installing the flexible flat cable, ensure that
NG
Insert at a slant.
connector
Insert straight into the interior.
flexible flat
cable
colored line
connector
connector
2 claw
6 connector
(CN2003)
5 flexible flat cable (9P)
the colored line is parallel to the connector after insertion.
OK
colored line
connector
2 claw
1 four screws
(BV3)
7 AMP board block
3 Remove the AMP board block
in the direction of the arrow.
4 connector
(CN009)
(CN010)
NG
Insert at a slant.
flexible flat
cable
MAP-S1
29