Panel Back Block - Sony MAP-S1 Service Manual

2-19. PANEL BACK BLOCK

– Rear bottom view –
2 filament tape
(sub material)
3 connector
(CN701)
4 connector
(CN007)
– Rear view –
8 Remove the panel back block
in the direction of the arrow.
1 three screws
(BV3)
A
9 connector
Note 1: Insert the connector straight into the interior.
There is a possibility that using this device
without the connector correctly installed will
damage it.
OK
Insert straight into
the interior.
connector
connector
NG
Insert only part way.
connector
connector
Note 2: When installing the flexible flat cable, ensure that
the colored line is parallel to the connector after insertion.
OK
Insert straight into the interior.
flexible flat
cable
colored line
connector
5 flexible flat cable (31P)
(CN003)
A
(CN5002)
7 three screws
(BV/ring)
MAP-S1
NG
Insert at a slant.
connector
connector
NG
Insert at a slant.
flexible flat
cable
colored line
connector
0 panel back block
7 two screws
(BV/ring)
6 screw
(BV3 10 ring)
25