Antenna 2.4 Ghz (Ant1), Holder (Antenna); Network Board Block - Sony MAP-S1 Service Manual

MAP-S1

2-20. ANTENNA 2.4 GHz (ANT1), HOLDER (ANTENNA)

Note: When the WiFi antenna (Ref. No. ANT1) is replaced, refer to
"CHECKING METHOD OF NETWORK CONNECTION" on
page 6.
1 antenna connector
(CON2)

2-21. NETWORK BOARD BLOCK

(Canadian)
Note 1: During reassembly, use new
binding band (taiton) to fasten
the wires back in place as
they were before disassembly.
1 Cut the binding band (taiton).
in a a
i ( i ) ( C )
binding band
(taiton)
bracket
PWB NET
clamp filter
(ferrite core)
(FC4)
20 ± 5 mm
AC inlet
(2P) (AC1)
26
3 screw
(BV/ring)
6 holder
(antenna)
2 connector
(CN3005)
Note 2: Insert the connector straight into the interior.
Insert straight into
the interior.
connector
connector
2 antenna 2.4 GHz
(ANT1)
4 boss
5 Rotate the claw of holder
(antenna) in the direction of
the arrow, align the hole of
panel back.
5 NETWORK board block
There is a possibility that using this device without
the connector correctly installed will damage it.
OK NG
Insert only part way.
connector
connector
claw
3 screw
(BV3 10 ring)
4 two screws
(BV/ring)
NG
Insert at a slant.
connector
connector