Panel (Front) Block-2 - Sony MAP-S1 Service Manual

MAP-S1
2-4.

PANEL (FRONT) BLOCK-2

1 Remove the panel (front) block
in the direction of an arrow.
7 panel (front) block
Note 1: Insert the connector straight into the interior.
There is a possibility that using this device without
the connector correctly installed will damage it.
OK
Insert straight into
Insert only part way.
the interior.
connector
connector
connector
14
6 flexible flat cable (23P)
(CN4806)
5 flexible flat cable (26P)
(CN4803)
NG NG
Insert at a slant.
connector
connector connector
sleeve ferrite clamp (FC1)
HP board
coating clip FRONT-L board
2 Remove the wire from the coating clip.
3 connector
(CN4005)
4 connector
(CN4201)
Note 2: When installing the flexible flat cable, ensure that
the colored line is parallel to the connector after insertion.
OK
Insert straight into the interior.
flexible flat
cable
colored line
connector
– –
NG
Insert at a slant.
flexible flat
cable
colored line
connector