Sony MAP-S1 Service Manual page 6

MAP-S1
NOTE OF REPLACING THE WiFi MODULE
When replacing the WiFi module (Ref. No. WIFI1), MAC address
and DEVICE_ID are changed. Print the page 7 and page 9, cut it,
and hand over it to the customer with the unit, when returning the
unit that the repair is completed to the customer.
PROCESSING OF REPLACING THE WiFi MODULE
When replacing the WiFi module (Ref. No. WIFI1), peel the ID
label stuck on the bottom side of the unit, and stick on the new ID
label (refer to the following fi gure) enclosed with the new WiFi
module (Ref. No. WIFI1)
1 Peel the ID label.
Device ID: XXXXXXXXXXXX
MAC Address: XX-XX-XX-XX-XX-XX
2 Stick on the
new ID label.
– Rear view –
DELETION METHOD OF USER REGISTRATION OF SEN
SERVICE
By checking Device ID, user registration of the internet video of
this unit can be compulsorily reset.
(Device ID is "the hexadecimal number of 12 fi gures")
When this unit needs compulsive reset, check the Device ID and
consult with a service headquarters.
Procedure:
1. Check the ID label stuck on the bottom side of the unit.
2. Device ID indicated on the ID label is recorded on a memoran-
dum etc.
(Device ID is "the hexadecimal number of 12 fi gures")
Device ID
Device ID: XXXXXXXXXXXX
MAC Address: XX-XX-XX-XX-XX-XX
– Rear view –
6
CHECKING METHOD OF NETWORK CONNECTION
It is necessary to check the network connection, when replacing
the WiFi module (Ref. No. WIFI1) and WiFi antenna (Ref. No.
ANT1). Check the connection of wireless and wired LAN, accord-
ing to the following method.
1. Checking Method of Wireless LAN Connection
Necessary Equipment:
• Access point supporting WPS
Procedure:
1. Check that network LAN cable is not connected to the unit.
2. Press the [ ] button to turn the power on.
?/1
3. Press the [FUNCTION] button on the remote commander to
select the "NETWORK" function.
4. Press the [MENU] button on the remote commander to the dis-
play the setting menu on the fl uorescent indicator tube.
5. Press the [V]/[v] buttons on the remote commander to select
the "Network Menu".
6. Press the [ENTER] button on the remote commander.
("WPS" lights up on the fl uorescent indicator tube)
7. Press the [ENTER] button on the remote commander.
("OK" fl ashes on the fl uorescent indicator tube)
8. Press the [ENTER] button on the remote commander.
("WPS" fl ashes on the fl uorescent indicator tube)
9. Press the [WPS] button on the access point.
10. When wireless LAN connection is started, "CONNECT"
fl ashes on the fl uorescent indicator tube.
11. When wireless LAN connection is completed, "COMPLETE"
appears for a moment on the fl uorescent indicator tube, then
" " appears on the fl uorescent indicator tube.
12. Press the [ ] button to turn the power off.
?/1
Note: Refer to the instruction manual about details of the setting method.
2. Checking method of wired LAN connection
Necessary Equipment:
• Router
• Network (LAN) cable
Procedure:
1. Connect the unit to the router with the network LAN cable.
2. Press the [ ] button to turn the power on.
?/1
3. Press the [FUNCTION] button on the remote commander to
select the "NETWORK" function.
4. Check that " " appears on the liquid crystal display.
5. Press the [ ] button to turn the power off.
?/1
Note: Refer to the instruction manual about details of the setting method.