Bracket Jack Block; Front-R Board, Front-Key Board - Sony MAP-S1 Service Manual

2-5.

BRACKET JACK BLOCK

2 screw
(BVTP2.6)
5 bracket jack block
(Except Canadian)
2 screw
(BVTP2.6)
Note 1: Insert the connector straight into the interior.
There is a possibility that using this device without
the connector correctly installed will damage it.
OK
Insert straight into
Insert only part way.
the interior.
connector
connector
connector
2-6.

FRONT-R BOARD, FRONT-KEY BOARD

– Panel (front) rear bottom view –
6 FRONT-R board
5 three screws
(BVTP2.6)
5 six screws
(BVTP2.6)
4 Draw out two jacks from two holes.
2 screw
(BVTP2.6)
3 coating
clip
– Panel (front) rear bottom view –
NG NG
Insert at a slant.
connector
connector connector
7 FRONT-KEY board
hole
Note 2: When installing the flexible flat cable, ensure that
the colored line is parallel to the connector after insertion.
OK
Insert straight into the interior.
flexible flat
cable
colored line
connector
4 flexible flat cable (9P)
(CN3520)
3 nut
Note: When installing the flexible flat cable, ensure that
the colored line is parallel to the connector after insertion.
OK
Insert straight into the interior.
flexible flat
cable
colored line
connector
MAP-S1
1 flexible flat cable (5P)
(CN4004)
NG
Insert at a slant.
flexible flat
cable
colored line
connector
2 knob (volume) assy
1 knob (enter) assy
NG
Insert at a slant.
flexible flat
cable
colored line
connector
15