Front Panel Block-1 - Sony GTK-XB60 Service Manual

2-15. FRONT PANEL BLOCK-1

• Continued on 2-16 (page 16).
1 two screws
front panel block
boss
2 Align the front panel block and wood
cabinet around the boss from the side,
insert a jig between them, and open a
gap of about 3 to 5 mm (perform at
the top, bottom, left, and right).
Note 1: When using a jig, please work carefully
so as not to damage the front panel
block and wood cabinet.
4 Insert a thick screwdriver into the bottom side
and widen the gap (perform at two places).
Note 2: Be careful because if a screwdriver is
inserted too far in, the speaker unit (WF)
may get damaged.
– Bottom view –
(M4 20)
bottom side
wood cabinet
about
3 to 5 mm
front side
front panel block
top side
total ten bosses (US, CND)
total eleven bosses (Except US, CND)
Note 3: This boss excludes US
3 Insert a thick screwdriver into the top side and
widen the gap (perform at two places).
Note 2: Be careful because if a screwdriver is
inserted too far in, the speaker unit (WF)
may get damaged.
– Top view –
GTK-XB60
1 two screws
(M4 20)
and CND models.
15