System Settings Submenu
Touch Control
•
Set where the USB commands from the touch panel is routed:
•
OPS routes the touch USB commands to the OPS module
•
External routes the touch USB command to the USB-B connector
•
Auto routes the touch USB commands to the OPS module if the OPS source is selected;
otherwise, they are connected to the USB-B connector
Enable Status LED
•
When enabled, the status LEDs on the back of the display behave as indicated on page
28. When disabled, the status LEDs are always turned off.
•
Options: Disable, Enable; Default: Enable
Pixel Orbit
•
Create slight frame motion to help avoid image retention
•
Options: Enable, Disable; Default: Disable
HDR Content
•
Set the action to take when HDR content is received and displayed on HDMI 1, HDMI 2
and the OPS input
•
Options: Auto, On, Off: Default: Auto
•
Auto: The display will adjust the image settings to conform to the HDR source
metadata.
•
On: The display will force all content to be displayed in HDR mode.
•
Note: When viewing SDR content in this mode, the image quality will not have the
correct appearance.
Planar UltraRes X Series User Manual
020-1396-00A
64
Page | 64