Using The Lifting Eyes - Planar UltraRes X Series User Manual

9.1

Using the Lifting Eyes

1. Slide the eye assemblies upward into the slots where shown. There will be a click when
they are fully seated.
2. Securely attach the lift mechanism and note the requirements below for spacing. For a
spreader bar application, the bar should be a minimum of 200mm (7.9") from the edge of
the display. For a single point lifting application, the angle of the line between the
eyehooks and the display must be 45° or greater.
3. Lift the panel into place.
4. Remove the lift mechanism attached to the lifting eyes.
Planar UltraRes X Series User Manual
020-1396-00A
25
Page | 25