Mounting With A Vesa Mount - Planar UltraRes X Series User Manual

8.

Mounting with a VESA Mount

The Planar UltraRes X Series can be mounted with the Planar Profile Mounting System (see
page 13) or with a VESA mount, available from Planar or other manufacturers.
If you purchased a VESA mount, you should have a received a separate box with mounting
supplies and an Installation manual. Follow these instructions carefully.
Keep in mind the following general installation guidelines:
•
Screw length is crucial and will vary depending on the type of mount you use. Total screw
length will include the penetration length plus the length required by the type of VESA
mount in use.
•
Mount spacers may be required to accommodate the protruding back panel of the OPS
slot.
Caution: Screws not sized to the depth specified can result in inadequate mounting strength or
damage to the internal components in the display. To prevent injury, this device must be
securely attached to the wall in accordance with the installation instructions supplied with the
mount. The mount must be secured to the Planar UltraRes X Series display using the four M8-
1.25 VESA mounting locations, and 10mm -15mm thread engagement is required for secure
mounting. Select the correct screw/spacer combination for the mount.
•
Prior to installation, make sure you know where all of the mounting points are located.
•
Follow all safety precautions outlined in the VESA Installation manual.
•
Verify the parts received with the list shown in the VESA Installation manual.
Planar UltraRes X Series User Manual
020-1396-00A
16
Page | 16