Planar UltraRes X Series User Manual page 19

4. Level and install the main support screws. At minimum, two pieces of mounting hardware
must be used on a single hanging mount component.
Note: When mounting, it is best practice to install hardware on either side of the hook to
distribute the load both vertically and horizontally. Failure to do this may result in the panel
flexing outward from the wall.
5. Place the opening in the template over the hook of the installed mount so it is resting
against the back of the mount, level, and slightly pull to the right to find the labeled hole
position for the model and orientation of the display being mounted. Mark this location on
the structure.
Note: The "V" notch in the template labeled for the model being installed can be used to
verify the center marks made in step 1 are correct. A slight variation in this location is okay
due to being able to slightly move the display horizontally once installed.
Planar UltraRes X Series User Manual
020-1396-00A
19
Page | 19