Loading Material - Roland MODELA Pro ZCL-650A User Manual

Part 4 Loading Material

4-2. Loading Material

1
Use the included hexagonal wrench (6 mm) to loosen the
support-side retaining screws, then move the support side
to match the size of the workpiece.
2
Securely tighten the support-side retaining screws.
3
Use the included hexagonal wrench (3 mm) to loosen the
set screws for the workpiece retainer attachment on the
drive and support sides, then insert the workpiece.
If the workpiece is flat, press the flat surface of the
workpiece against the workpiece brace surface of the
workpiece retainer attachment.
4
Tighten the set screws securely, using even force.
If the workpiece is thin and the set screws do not reach,
insert the included spacer or the like and secure in place.
Take care not to apply excessive force when securing the workpiece in place. Doing so may cause the workpiece to warp or deform during
cutting. When you are using a soft workpiece made of foamed material or the like, precision may be affected by slipping of the workpiece
during cutting or twisting during rotation.
When you are using the included workpiece retainer attachment, we recommend using a workpiece with a flat bottom surface.
16
Set screw
Spacer