Table of Contents
Advertisement
Part 3 Using the Operation Panel
Descriptions of the Menus
12-1 ROTATE
12-2 Z CENTER MODE
12-3 RESET Y POS
12-4 Y CENTER MODE
12-5 CENTER-Y OFFSET
12-6 CENTER-Z OFFSET
12-7 ROTARY USE TIME
14
Stored in memory : No
Setting range : 0 to 360 degrees
Steps : 15
This references the user origin point (workpiece origin point) and rotates the A axis by the
selected angle.
This uses the rotation-axis center sensor to set the Z-axis origin point at a location where the
tool tip coincides with the height of the A-axis center.
This resets the Y-axis origin point at the location set previously with [Y CENTER MODE].
Even after the Y-axis origin point has been set at another location, you can reset it to the A-
axis center by running this item.
Running this item when [Y CENTER MODE] has never been run once sets the Y-axis origin
point at the center of the maximum cutting range.
This uses the rotational-center sensor to set the Y-axis origin point at a location where the
tool center coincides with the A-axis center.
Running this item initializes the [CENTER-Y OFFSET] value to zero.
Stored in memory : Yes
Factory default : 0
Setting range : -1,000 to 1,000 µm
Steps : 10
This corrects coordinate misalignment of the Y-axis origin point that [Y CENTER MODE]
sets. Entering a positive value applies correction toward the back, and entering a negative
value applies correction toward the front.
Running [Y CENTER MODE] initializes this value to zero.
Stored in memory : Yes
Factory default : 0
Setting range : -1,000 to 1,000 µm
Steps : 10
This corrects coordinate misalignment of the Z-axis origin point that [Z CENTER MODE]
sets. Entering a positive value applies correction upward, and entering a negative value ap-
plies correction downward.
This displays the total usage time of the rotary axis unit. The value cannot be reset to zero. It
keeps count of spindle rotation time when the rotary axis unit is connected.
Advertisement
Table of Contents
