1-8 Loading a Workpiece for Cutting
Fasten the spindle, tool, and
material securely in place.
Otherwise they may come loose during
cutting, resulting in injury.
NOTICE
When mounting a vise or loading a workpiece while a tool is installed, take care to avoid being injured by the
tool.
This section describes how to load a workpiece when using the T-slot clamp included with the unit.
A spacer for the T-slot table (ZA-600/500 series) is optionally available and should be purchased if needed.
For more information on how to install it on the unit, see "Part 3 Appendix."
Place the workpiece on the T-slot table.
1
Part 1 Setting Up
Workpiece
47