Toshiba PORTEGE R400 Maintenance Manual page 270

4.19 RGB board
4.19 RGB board
Removing the RGB board
The following describes the procedure for removing the RGB board. (See Figure 4-31.)
1. Peel off the glass tape.
2. Remove the following screw.
• M2×4B
3. Disconnect the RGB cable from the connector CN9620 on the RGB board and
CN9520 on the system board.
4. Disconnect the sensor cable from the connector CN9720 on the RGB board.
5. Remove the RGB board from the slot.
CN9720
RGB board
PORTÉGÉ R400 Maintenance Manual (960-623)
BIND screw
M2x4B BIND
CN9620
Sensor cable
Figure 4-31 Removing the RGB board
4 Replacement Procedures
×1
RGB cable
[CONFIDENTIAL]
Glass tape
CN9520
4-51