Toshiba PORTEGE R400 Maintenance Manual page 259

4 Replacement Procedures
4.13 UWB module
Removing the UWB module
To remove the UWB module, follow the steps below. (See Figure 4-24.)
CAUTION: Do not try to remove the UWB module with the computer turned on. It may
cause damages to the computer or the UWB module. Do not touch the
connectors on the UWB module on the computer. Debris on the connectors
may cause the UWB module access problems.
1. Remove the following screws.
• M2×4B BIND screw
2. Disconnect the Bluetooth antenna cable (brown) and UWB antenna cables (yellow
and purple) from the UWB module using an antenna coaxial cable disconnector.
3. Disconnect the UWB module from the connector CN2630 on the system board.
UWB module
4-40 [CONFIDENTIAL]
×2
Bluetooth antenna
cable (brown)
CN2630
Figure 4-24 Removing the UWB module
M2×4B BIND
PORTÉGÉ R400 Maintenance Manual (960-623)
4.13 UWB module
UWB antenna
cable (yellow)
UWB antenna
cable (purple)