4.12 Touch pad
Installing the Touch pad
The following describes the procedure for installing the touch pad. (See Figure 4-20 to 4-23.)
1. Connect the touch pad cable to the connector on the touch pad.
2. Stick the double-sided tape in place.
3. Arrange the touch pad cable and install the touch pad to the slot and secure it with
the following screws.
• M2×3C
CAUTION: Arrange the touch pad cable as shown in the figure below.
Touch pad cable
4. Install the touch pad cover while engaging five latches.
5. Connect the touch pad cable to the connector CN3240 on the system board.
PORTÉGÉ R400 Maintenance Manual (960-623)
S-THIN HEAD screw
Back of the cover assembly
4 Replacement Procedures
×2
[CONFIDENTIAL]
4-39