Table of Contents
Advertisement
Tone
You may often need to use Touch Tone dial signals to perform special
operations by phone. Bank-by-phone and voice mail are two examples of
systems that require these signals. If you have pulse service, you can still
send Touch Tone signals by following these steps.
1. Dial the number using pulse dialing.
2. When the remote phone answers, press
3. Dial the remaining numbers required by the service. The machine
Flash(R)
Some special phone services require a switch-hook signal for proper
operation. For example, if you have call waiting, you can put a call on hold
and take a second call on the same line by pressing the switch-hook button.
Pressing Flash(R) performs the equivalent of a switch-hook operation.
1. When you are on the telephone and hear the call waiting signal, press
2. Press Flash(R) again to talk to the first caller again.
Note: If you do not have a special service that uses the switch-hook signal, donÕt
2.34
Other Functions
press will be sent as Touch tones for the remainder of the call.
returns to the pulse mode after you finish the call.
Flash(R) once. The first caller is on hold and you are speaking to the
second caller.
press Flash(R) during a call. If you do, you could disconnect the line.
. Any numbers you now
Advertisement
Table of Contents
