Table of Contents
Advertisement
2.28
Automatic Dialing
3. The display asks you to enter a name. Enter the desired name (up to
20 digits). For information on how to enter names, see page 2.4.
Or
If you donÕt want to assign a name, skip this step.
If you assign a name to the number, the name appears in the display
when you press the one-touch button.
4. Press Enter when the name appears correctly or without entering a
name.
5. To set another one-touch number, press the desired one-touch
button and repeat steps 2 through 5.
Or
To return to Standby mode, press Stop.
Sending a Fax Using a One-Touch Number
1. Load a document you want to send a fax.
2. Press the one-touch button (01 through 20) to which you stored a
number. The number will be automatically dialed, then the document
begins to transmit when the remote fax machine answers the phone.
Using Address Label
A One-touch label sheet is included with your machine. As you store
numbers in one-touch dial buttons, make a note of the numbers on the
label to remind you which number is stored in each position.
1. Remove the clear cover and
label using an instrument
with a pointed end, as
shown at right.
2. Write information on the
label and replace the label
and cover.
You may want to use pencil
in case you wish to change
these numbers later.
Advertisement
Table of Contents
