Actuator Model Selection - Emerson Keystone EPI2 63 Installation, Operation And Maintenance Manual

Section 6: Actuator Configuration
October 2020
6.2.13

Actuator Model Selection

The frames relevant to models 63/125 and 250/500 can be set to operate with a 63 Nm
or 125 Nm motor and a 250 Nm or 500 Nm motor respectively. The difference is based on
the technical characteristics of the electric motor itself.
Actuator model 63
•
•
•
•
•
•
Actuator model 125
•
•
•
•
•
•
Actuator model 250
•
•
•
•
•
•
36
Enter set up configuration: move switch SW3 to position ON (configuration function)
Move switch SW4 to position 9
Move switch SW6 to position 0
Confirm by pushing ENTER pushbutton, SW5
When pushing SW5, the red LED switches on for confirmation
Exit set up configuration (move switch SW3 to position 1) or proceed with
the next parameter
Enter set up configuration: move switch SW3 to position ON (configuration function)
Move switch SW4 to position 9
Move switch SW6 to position 1
Confirm by pushing ENTER pushbutton SW5
When pushing SW5, the red LED switches on for confirmation
Exit set up configuration (move switch SW3 to position 1) or proceed with
the next parameter
Enter set up configuration: move switch SW3 to position ON (configuration function)
Move switch SW4 to position 9
Move switch SW6 to position 0
Confirm by pushing ENTER pushbutton SW5
When pushing SW5, the red LED switches on for confirmation
Exit set up configuration (move switch SW3 to position 1) or proceed with
the next parameter
Installation, Operation and Maintenance Manual
MAN-10-04-100-0711-EN Rev. 0
Actuator Configuration