Removal Of The Control Unit Cover - Emerson Keystone EPI2 63 Installation, Operation And Maintenance Manual

Section 6: Actuator Configuration
October 2020
6.1

Removal of the Control Unit Cover

Using a 5 mm Allen key, loosen the four screws and remove the cover.
NOTE
When setting the actuator parameters do not operate the actuator neither remotely nor locally.
WARNING
!
Pay attention not to damage the joint surfaces of the cover.
NOTE
In case the screws of the cover must be replaced, SS Class A4 grade 80 screw must be used
with minimum yield strength 600 N/mm
Once the configuration is completed, reassemble the actuator cover.
Figure 14
28
Removal of the Control Unit Cover
Installation, Operation and Maintenance Manual
.
2
MAN-10-04-100-0711-EN Rev. 0
Actuator Configuration