Section 4: Installation
October 2020
4.10
Cables Connections
Before applying voltage to the Keystone EPI2 check that the electrical parameters
(supply voltage and current) shown on the nameplate and on the attached wiring
diagram are correct for the installation.
Figure 10
NOTE
All the accessories which equip the Keystone EPI2, in particular the cable glands, must be
certified according to the Standard Directive and specific Rules applying to the products.
!
Do not remove earth connection X while connecting the actuator to plant earthing.
20
Overview of the Electrical Connections
WARNING
Installation, Operation and Maintenance Manual
MAN-10-04-100-0711-EN Rev. 0
Installation