Section 6: Actuator Configuration - Emerson Keystone EPI2 63 Installation, Operation And Maintenance Manual

Installation, Operation and Maintenance Manual
MAN-10-04-100-0711-EN Rev. 0

Section 6: Actuator Configuration

Before connecting power to the actuator, check that the voltages are correct and
according to the indications on the nameplate. Wrong power supply could cause
permanent damage to the electrical components.
The configuration of the Keystone EPI2 actuator can be carried out through the control
panel inside the actuator control system. To access the panel, remove the actuator cover
and when the configuration is complete replace the cover, following the procedures
indicated on next page.
NOTE
When optional local control panel OM3 is installed and the actuator setting is done by means
of the pushbuttons on the logic board, the remote controls do not have to be energized.
Actuator Configuration
Section 6: Actuator Configuration
October 2020
27