Base Wiring Diagram - Emerson Keystone EPI2 63 Installation, Operation And Maintenance Manual

Section 4: Installation
October 2020
4.11

Base Wiring Diagram

Figure 11
NOTE
1.
2.
Figure 12
a. Standard configuration
b. 2 wires setting (to be configured)
Contact open for actuator closing
Contact close for actuator opening
3.
4.
5.
6.
!
It is under user responsibility to limit the rated impulse voltage level at 1500 V.
22
L1 L2 L3 35 36 32 33 34
Note 1 Remote commands
(Note 2, 5)
Power connection L1-L2 for V DC or V AC single phase motor supply from 24 V to
48 V or from 100 V to 240 V.
Power connection L1-L2-L3 for 3-phase motor supply from 208 V to 575 V
(check the actuator label for the correct voltage to be applied).
Remote command options.
Internal supply 24 V DC
Internal supply 24 V DC
Contacts shown in intermediate position CLC1-CLC2 end of travel signaling in closing.
Contacts shown in intermediate position OPC1-OPC2 end of travel signaling in opening.
Output contact rating 240 V AC / 5 A ; 30 V DC / 5A ; 120 V DC / 0.5 A.
Output contacts (when used) have to be feed with the same external voltage.
Control command rating 24 to 120 V AC or DC.
Control signal: minimum duration>600 ms
Blinker or Local Selector monitoring function (when OM3 is present) to be configured
WARNING
Installation, Operation and Maintenance Manual
BLINKER LOCAL
MONITOR SELECTOR
RELAY RELAY CLC1 CLC2
1 2 3 4 20 21 22 23
Output contacts
Note 4, 6
(Note 3, 4)
External supply 24 / 120 V AC or 24 / 120 V DC
External supply 24 / 120 V AC or 24 / 120 V DC
MAN-10-04-100-0711-EN Rev. 0
OPC1 OPC2
24 25 26 27 28 29
Optional
module OM3
Contact open for actuator closing
Contact close for actuator opening
30 31
Installation