WPC System
USER GUIDE
Attach the box to the Grid
Position the box on the outside of the bracket on the left side of the grid. There are two M4x20mm Cap head screws supplied
with the sensor. These go through the holes in the bottom left and top right of the box into the threaded holes in the grid bracket.
Tighten using an M3 Allen Key to ensure a tight fit.
Refit the Lid
The lid can be re-fitted, check that the gasket on the underside of the lid edge is intact to ensure that the lid is sealed once
screwed in position. Note that the design of the box is such that the mounting and lid screws are positioned outside the lid
gasket to ensure that there will be no moisture ingress through their holes. All screws are stainless steel to avoid corrosion when
used outdoors.
WPC User Guide v1.0
Page 31