Remote Node Filter; Figure 4-2 Menu 11.1 - Remote Node Filter - ZyXEL Communications P-202 User Manual

Prestige 201 ISDN Access Router
successful authentication, please make sure that you specify the correct authentication protocol when
connecting to such an implementation.

4.1.3 Remote Node Filter

Use Menu 11.1 – Remote Node Filter to specify the filter set(s) to apply to the incoming and outgoing
traffic between this remote node and the Prestige and to prevent certain packets from triggering calls. You
can specify up to 4 filter sets separated by comma, e.g., 1, 5, 9, 12, in each filter field. The default is no
filters.
Note that spaces are accepted in this field. For more information on defining the filters, see the chapter on
Filter Configuration. The Prestige comes with a prepackaged filter set, NetBIOS_WAN, that blocks
NetBIOS packets (call protocol filter = 1). You can include this in the call filter sets if you wish to prevent
NetBIOS packets from triggering calls to a remote node.
Remote Node Configuration
Menu 11.1 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters
Figure 4-2 Menu 11.1 – Remote Node Filter
=
4-5