Outgoing Authentication Protocol - ZyXEL Communications P-202 User Manual

Field
BACP
Single User Account
Telco Options:
Transfer Type
Allocated Budget (min.)
Period (hr.)
Schedule Sets
Session Option:
Edit Filter Sets
Session Option:
Idle Timeout (sec)
Once you have completed filling in Menu 11– Remote Node Profile, press [Enter] at the message
[Press ENTER to Confirm...] to save your configuration, or press [Esc] at any time to cancel.

4.1.2 Outgoing Authentication Protocol

Generally speaking, you should employ the strongest authentication protocol possible, for obvious reasons.
However, some vendor's implementation includes specific authentication protocol in the user profile. It will
disconnect if the negotiated protocol is different from that in the user profile, even when the negotiated
protocol is stronger than specified. If you encounter the case where the peer disconnects right after a
4-4
Description
Your Prestige negotiates the Secondary Phone
number for a dial-up line from the peer when BACP
(Bandwidth Allocation Control Protocol) is enabled.
Use the space bar to toggle this field to Yes or No to
enable or disable the Single User Account feature for
your Prestige.
This field specifies the type of connection between the
Prestige and this remote node. When set to Leased, the
Allocated Budget and Period do not apply.
This field sets a ceiling for outgoing call time for this
remote node. The default for this field is 0 for no budget
control.
This field sets the time interval to reset the above
outgoing call budget control.
You can select up to four schedule sets here and
configure them in Menu 26. For more details please
refer to the chapter Schedule Setup.
Use the space bar to toggle this field to Yes and press
[Enter] to open Menu 11.5 to edit the filter sets. See the
Remote Node Filter section for more details.
This value specifies the number of idle seconds that
elapses before the remote node is automatically
disconnected. Idle seconds is the period of time when
no data is transmitted from your Prestige. The default is
100 seconds.
Prestige 201 ISDN Access Router
Options
Enable
(default)/
Disable
Yes/No
64k/
Leased
Default= No
Default=100
Remote Node Configuration