Wpa-Psk/Wpa2-Psk; Figure 64 Network > Wireless Lan > General: Wpa-Psk/Wpa2-Psk - ZyXEL Communications ZyXEL NBG420N User Manual

Chapter 7 Wireless LAN
Table 31 Network > Wireless LAN > General: Static WEP
LABEL
Key 1 to Key 4
Apply
Reset

7.5.3 WPA-PSK/WPA2-PSK

Click Network > Wireless LAN to display the General screen. Select WPA-PSK or WPA2-
PSK from the Security Mode list.
Figure 64 Network > Wireless LAN > General: WPA-PSK/WPA2-PSK
98
DESCRIPTION
The WEP keys are used to encrypt data. Both the NBG420N and the wireless
stations must use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal
characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal
characters ("0-9", "A-F").
You must configure at least one key, only one key can be activated at any one time.
The default key is key 1.
Click Apply to save your changes back to the NBG420N.
Click Reset to reload the previous configuration for this screen.
NBG420N User's Guide