Remote Management And Nat; System Timeout; Www Screen; Figure 126 Management > Remote Mgmt > Www - ZyXEL Communications ZyXEL NBG420N User Manual

Chapter 18 Remote Management
1 You have disabled that service in one of the remote management screens.
2 The IP address in the Secured Client IP Address field does not match the client IP
address. If it does not match, the NBG420N will disconnect the session immediately.
3 There is already another remote management session with an equal or higher priority
running. You may only have one remote management session running at one time.
4 There is a firewall rule that blocks it.

18.1.2 Remote Management and NAT

When NAT is enabled:
• Use the NBG420N's WAN IP address when configuring from the WAN.
• Use the NBG420N's LAN IP address when configuring from the LAN.

18.1.3 System Timeout

There is a default system management idle timeout of five minutes (three hundred seconds).
The NBG420N automatically logs you out if the management session remains idle for longer
than this timeout period. The management session does not time out when a statistics screen is
polling. You can change the timeout period in the System screen

18.2 WWW Screen

To change your NBG420N's World Wide Web settings, click Management > Remote
MGMT to display the WWW screen.
Figure 126 Management > Remote MGMT > WWW
The following table describes the labels in this screen
Table 79 Management > Remote MGMT > WWW
LABEL
Server Port
Server Access
210
DESCRIPTION
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the NBG420N using
this service.
NBG420N User's Guide