Remote Node Filter - ZyXEL Communications ZyXEL Prestige 310 User Manual

Prestige 310 Broadband Sharing Gateway
Field
Metric The metric represents the "cost" of transmission for routing purposes.
IP routing uses hop count as the measurement of cost, with a minimum
of 1 for directly connected networks. Enter a number that approximates
the cost for this link. The number need not be precise, but it must be
between 1 and 15. In practice, 2 or 3 is usually a good number.
Private This parameter determines if the Prestige will include the route to this
remote node in its RIP broadcasts. If set to Yes, this route is kept
private and not included in RIP broadcast. If No, the route to this remote
node will be propagated to other hosts through RIP broadcasts.
RIP Press the [SPACE BAR] to select the WAN RIP direction from Both/
None/In Only/Out Only and None.
Version Press the [SPACE BAR] to select the RIP version from RIP-1/RIP-
2B/RIP-2M.
Multicast Turn on/off IGMP support and select the version from IGMP-v2/IGMP-
v1/None.
Once you have completed filling in the Network Layer Options Menu, press [Enter] to return to Menu 11.
Press [Enter] at the message [Press ENTER to Confirm...] to save your configuration, or press [Esc] at
any time to cancel.
5.3

Remote Node Filter

Move the cursor to the field Edit Filter Sets in Menu 11.1, then press the [SPACE BAR] to toggle and set
the value to YES. Press [ENTER] to open Menu 11.5 – Remote Node Filter.
Use Menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote
node and the Prestige and to prevent certain packets from triggering calls. You can specify up to 4 filter sets
separated by a comma, e.g., 1, 5, 9, 12, in each filter field.
Note that spaces are accepted in this field. For more information on defining the filters, please refer to
Chapter 7. Note that for PPTP and PPPoE encapsulation, you can also specify remote node call filter sets.
5-10
Description Example
1 to 15
Yes/No
None
(default)
RIP-1
None
Remote Node Setup