Editing Tcp/Ip Options (With Pppoe Encapsulation); Figure 5-6 Remote Node Network Layer Options - ZyXEL Communications ZyXEL Prestige 310 User Manual

5.2.2 Editing TCP/IP Options (with PPPoE Encapsulation)

Make sure that Encapsulation is set to PPPoE in Menu 11.1. Then move the cursor to the Edit IP field in
Menu 11.1, press the [SPACE BAR] to toggle No to Yes. Press [Enter] to open Menu 11.3 - Network
Layer Options.
Press Space Bar to Toggle.
The next table gives you instructions about configuring remote node network layer options.
Table 5-6
Field
IP Address If your ISP did not assign you an explicit IP address, select Dynamic;
Assignment otherwise select Static and enter the IP address & subnet mask in the
following fields.
Rem IP Address If you have a Static IP Assignment, enter the IP address assigned to
the remote node.
Rem IP Subnet If you have a Static IP Assignment, enter the subnet mask assigned to
Mask the remote node.
My WAN Addr Some implementations, especially the UNIX derivatives, require the
WAN link to have a separate IP network number from the LAN and
each end must have a unique address within the WAN network number.
If this is the case, enter the IP address assigned to the WAN port of
your Prestige.
Note that this is the address assigned to your local Prestige, not the
remote router.
Single User Use the [SPACE BAR] to choose Yes or No.
Account
Remote Node Setup
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
Rem IP Address= N/A
Rem Subnet Mask= N/A
My WAN Addr= 0.0.0.0
Single User Account= Yes
Metric= 1
Private= No
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Figure 5-6 Remote Node Network Layer Options
Remote Node Network Layer Options Menu Fields
Prestige 310 Broadband Sharing Gateway
Description Example
Dynamic
Yes
5-9