Collecting General Setup Information; Collecting Idsl Information - ZyXEL Communications Prestige 128L User Manual

Collecting General Setup Information

Your Prestige requires the following system information. You can obtain
all the pertinent information from your network administrator. Record
this information into the worksheet as it becomes available. This
worksheet will later be referred to as you configure your Prestige.
System Name - This is the name given to your Prestige for
identification purposes. This name should be no more than 8
alphanumeric characters. Spaces are not allowed, but "-" and "_"
are accepted. This name can be obtained remotely via the SNMP
management protocol and will be displayed as the prompt when the
user enters the Command Mode.
Route IP Field - For Internet access, you will need to enable the
Route IP Field. See Chapter 4 for more details on configuring your
Prestige for Internet access. To support Novell IPX, or Bridging,
enable the appropriate protocol and reference the related chapters
for detailed information.
You have now collected all of the general setup information you need.
Make sure that you have entered all the values onto the worksheet
before proceeding to the next section.

Collecting IDSL Information

Service Type - There are two options: Client or Server. One
IDSL router should be set as the client, and the other as server.
Transfer Type - There are two options: Leased 128 or Leased
64. The data will be transmitted in 128Kbps if Leased128 is
selected; otherwise, it will be transmitted in 64Kbps. The transfer
type must be set the same for both the client and server router.
Before You Begin 9