ZyXEL Communications ES-2108 User Manual page 47

Table 5 Navigation Panel Links (continued)
LINK
Advanced
Application
VLAN
Static MAC
Forwarding
Filtering
Spanning Tree
Protocol
Bandwidth
Control
Broadcast Storm
Control
Mirroring
Link Aggregation This link takes you to a screen where you can logically aggregate physical links to
Port
Authentication
Port Security
Queuing Method
IP Application
Static Route
DiffServ
Advanced
Management
Maintenance
Access Control
Diagnostic
Cluster
Management
MAC Table
ARP Table
Chapter 4 The Web Configurator
DESCRIPTION
This link takes you to screens where you can configure port-based or 802.1Q VLAN
(depending on what you configured in the Switch Setup menu).
This link takes you to screens where you can configure static MAC addresses for a
port. These static MAC addresses do not age out.
This link takes you to a screen to set up filtering rules.
This link takes you to screens where you can configure the STP/RSTP to prevent
network loops.
This link takes you to screens where you can cap the maximum bandwidth allowed
from specified source(s) to specified destination(s).
This link takes you to a screen to set up broadcast filters.
This link takes you to screens where you can copy traffic from one port or ports to
another port in order that you can examine the traffic from the first port without
interference
form one logical, higher-bandwidth link.
This link takes you to a screen where you can configure RADIUS (Remote
Authentication Dial-In User Service), a protocol for user authentication that allows
you to use an external server to validate an unlimited number of users.
This link takes you to a screen where you can activate MAC address learning and
set the maximum number of MAC addresses to learn on a port.
This link takes you to a screen where you can configure SPQ or WRR with
associated queue weights for each port.
This link takes you to screens where you can configure static routes. A static route
defines how the switch should forward traffic by configuring the TCP/IP parameters
manually.
This link takes you to screens where you can enable DiffServ and set DSCP-to-
IEEE802.1p mappings.
This link takes you to screens where you can perform firmware and configuration file
maintenance as well as reboot the system.
This link takes you to screens where you can change the system login password
and configure SNMP and remote management.
This link takes you to screens where you can view system logs and test port(s).
This link takes you to a screen where you can configure clustering management and
view its status.
This link takes you to a screen where you can view the MAC addresses (and types)
of devices attached to what ports and VLAN IDs.
This link takes you to a screen where you can view the MAC addresses – IP
address resolution table.
ES-2108 Series User's Guide
47