Configuring Static Dhcp - ZyXEL Communications ZyAIR G-2000 Plus User Manual

ZyAIR G-2000 Plus User's Guide
Table 17 LAN IP
LABEL
Allow between LAN
and WAN
Apply
Reset

5.5 Configuring Static DHCP

This table allows you to assign IP addresses on the LAN to specific individual computers
based on their MAC Addresses.
Every Ethernet device has a unique MAC (Media Access Control) address. The MAC address
is assigned at the factory and consists of six pairs of hexadecimal characters, for example,
00:A0:C5:00:00:02.
To change your ZyAIR's Static DHCP settings, click LAN, then the Static DHCP tab. The
screen appears as shown.
75
DESCRIPTION
Select this check box to forward NetBIOS packets from the LAN to the WAN and
from the WAN to the LAN. If your firewall is enabled with the default policy set to
block WAN to LAN traffic, you also need to enable the default WAN to LAN
firewall rule that forwards NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the LAN to the
WAN and from the WAN to the LAN.
Click Apply to save your changes back to the ZyAIR.
Click Reset to begin configuring this screen afresh.
Chapter 5 LAN Screens