Figure 136 Menu 11.1 Remote Node Profile For Ethernet Encapsulation; Table 95 Menu 11.1 Remote Node Profile For Ethernet Encapsulation - ZyXEL Communications ZyAIR G-2000 Plus User Manual

ZyAIR G-2000 Plus User's Guide
Figure 136
Rem Node Name= ChangeMe
Active= Yes
Encapsulation= Ethernet
Service Type= Standard
Service Name= N/A
Outgoing:
My Login= N/A
My Password= N/A
Retype to Confirm= N/A
Server= N/A
Relogin Every (min)=
Press ENTER to Confirm or ESC to Cancel:
The following table describes the fields in this menu.

Table 95 Menu 11.1 Remote Node Profile for Ethernet Encapsulation

FIELD
Rem Node Name
Active
Encapsulation
Service Type
Outgoing
My Login
My Password
Retype to Confirm
Server
Relogin Every
(min)
281
Menu 11.1 Remote Node Profile for Ethernet Encapsulation
N/A
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
Enter a descriptive name for the remote node. This field can be up to eight
characters.
Press [SPACE BAR] and then [ENTER] to select Yes (activate remote node) or
No (deactivate remote node).
Ethernet is the default encapsulation. Press [SPACE BAR] and then [ENTER] to
change to PPPoE or PPTP encapsulation.
Press [SPACE BAR] and then [ENTER] to select from Standard, RR-Toshiba
(RoadRunner Toshiba authentication method), RR-Manager (RoadRunner
Manager authentication method), RR-Telstra or Telia Login. Choose one of the
RoadRunner methods if your ISP is Time Warner's RoadRunner; otherwise
choose Standard.
This field is applicable for PPPoE encapsulation only. Enter the login name
assigned by your ISP when the ZyAIR calls this remote node. Some ISPs append
this field to the Service Name field above (e.g., jim@poellc) to access the PPPoE
server.
Enter the password assigned by your ISP when the ZyAIR calls this remote node.
Valid for PPPoE encapsulation only.
Type your password again to make sure that you have entered it correctly.
This field is valid only when RoadRunner is selected in the Service Type field.
The ZyAIR will find the RoadRunner Server IP automatically if this field is left
blank. If it does not, then you must enter the authentication server IP address
here.
This field is available when you select Telia Login in the Service Type field.
The Telia server logs the ZyAIR out if the ZyAIR does not log in periodically. Type
the number of minutes from 1 to 59 (30 recommended) for the ZyAIR to wait
between logins.
Menu 11.1 - Remote Node Profile
Route= IP
ISP= No
Apply Alias= None
Edit IP= No
Session Options:
Edit Filter Sets= No
Chapter 25 Remote Node Configuration