Table of Contents
Advertisement
P-662H/HW-D Series User's Guide
The following table describes the labels in this screen.
Table 15 Wireless LAN Setup Wizard 1
LABEL
Active
Enable OTIST
Setup Key
Back
Next
Exit
3 Configure your wireless settings in this screen. Click Next.
Figure 32 Wireless LAN Setup Wizard 2
74
DESCRIPTION
Select the check box to turn on the wireless LAN.
Note: You can also activate the wireless LAN by pressing the
RESET button for 1 second.
Select the check box to enable OTIST if you want to transfer your ZyXEL
Device's SSID and WEP or WPA-PSK security settings to wireless clients that
support OTIST and are within transmission range.
You must also activate and start OTIST on the wireless client at the same time.
The process takes three minutes to complete.
Note: You can start OTIST by pressing the RESET button for 3
seconds.
Type an OTIST Setup Key of up to eight ASCII characters in length. Be sure to
use the same OTIST Setup Key on the ZyXEL Device and wireless clients.
Click Back to display the previous screen.
Click Next to proceed to the next screen.
Click Exit to close the wizard screen without saving.
Chapter 3 Wizard Setup for Internet Access
Advertisement
Table of Contents
Troubleshooting
