Id Type And Content Examples; Table 90 Local Id Type And Content Fields; Table 91 Peer Id Type And Content Fields - ZyXEL Communications 802.11g ADSL 2+ 4-Port Security Gateway HW-D Series User Manual

P-662H/HW-D Series User's Guide
With main mode (see
provide identity protection. In this case the ZyXEL Device can only distinguish between up to
12 different incoming SAs that connect from remote IPSec routers that have dynamic WAN IP
addresses. The ZyXEL Device can distinguish up to 12 incoming SAs because you can select
between three encryption algorithms (DES, 3DES and AES), two authentication algorithms
(MD5 and SHA1) and two key groups (DH1 and DH2) when you configure a VPN rule (see
Section 16.13 on page
incoming SAs.
The type of ID can be a domain name, an IP address or an e-mail address. The content is the IP
address, domain name, or e-mail address.

Table 90 Local ID Type and Content Fields

LOCAL ID TYPE= CONTENT=
IP
DNS
E-mail

Table 91 Peer ID Type and Content Fields

PEER ID TYPE= CONTENT=
IP
DNS
E-mail

16.9.1 ID Type and Content Examples

Two IPSec routers must have matching ID type and content configuration in order to set up a
VPN tunnel.
246
Section 16.12.1 on page
254). The ID type and content act as an extra level of identification for
Type the IP address of your computer or leave the field blank to have the ZyXEL
Device automatically use its own IP address.
Type a domain name (up to 31 characters) by which to identify this ZyXEL Device.
Type an e-mail address (up to 31 characters) by which to identify this ZyXEL
Device.
The domain name or e-mail address that you use in the Content field is used for
identification purposes only and does not need to be a real domain name or e-mail
address.
Type the IP address of the computer with which you will make the VPN connection
or leave the field blank to have the ZyXEL Device automatically use the address in
the Secure Gateway field.
Type a domain name (up to 31 characters) by which to identify the remote IPSec
router.
Type an e-mail address (up to 31 characters) by which to identify the remote IPSec
router.
The domain name or e-mail address that you use in the Content field is used for
identification purposes only and does not need to be a real domain name or e-mail
address. The domain name also does not have to match the remote router's IP
address or what you configure in the Secure Gateway Addr field below.
253), the ID type and content are encrypted to
Chapter 16 VPN Screens