Wireless Network Setup; Figure 15 Wireless Lan; Table 6 Connection Wizard > System Information; Table 7 Wireless Lan Setup Wizard 2 - ZyXEL Communications P-2302HWUDL-P1 Series User Manual

Chapter 3 Wizard Setup
The following table describes the labels in this screen.
Table 6 Connection Wizard > System Information
LABEL
System Name
Domain Name
< Back
Next >
Exit

3.2.3 Wireless Network Setup

Use the following screens to set up your wireless LAN.
3.2.3.1 Wireless LAN - General Information
Configure your wireless settings in this screen, then click Next.

Figure 15 Wireless LAN

The following table describes the labels in this screen.

Table 7 Wireless LAN Setup Wizard 2

LABEL
Name(SSID)
Channel
Selection
50
DESCRIPTION
Enter your computer's "Computer Name". See
information. This is for identification purposes, but some ISPs also check this field.
This name can be up to 30 alphanumeric characters long. Spaces are not allowed,
but dashes "-" and underscores "_" are accepted.
Enter the domain name entry that is propagated to DHCP clients on the LAN. If
you leave this blank, the domain name obtained from the ISP is used. Use up to
38 alphanumeric characters. Spaces are not allowed, but dashes "-" and periods
"." are accepted.
Click this to go to the previous screen.
Click this to go to the next screen.
Click this to close this screen and return to the main screen.
DESCRIPTION
Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless
LAN.
If you change this field on the ZyXEL Device, make sure all wireless stations use the
same SSID in order to access the network.
The range of radio frequencies used by IEEE 802.11b/g wireless devices is called a
channel. Select a channel ID that is not already in use by a neighboring device.
Section 22.1 on page 261
P-2302HWUDL-P1 Series User's Guide
for more