Figure 52 Wan Dial Backup Modem Setup; Table 29 Wan Dial Backup Modem Setup - ZyXEL Communications 802.11g ADSL 2+ 4-Port Security Gateway HW-D Series User Manual

P-662H/HW-D Series User's Guide

Figure 52 WAN Dial Backup Modem Setup

The following table describes the labels in this screen.

Table 29 WAN Dial Backup Modem Setup

LABEL
AT Command
Strings
Dial
Drop
Answer
Drop DTR When
Hang Up
AT Response
Strings
CLID
Called ID
Speed
Call Control
Dial Timeout
Retry Count
106
DESCRIPTION
Type the AT Command string to make a call. Example: atdt
Type the AT Command string to drop a call. "~" represents a one second wait, for
example, "~~+++~~ath" can be used if your modem has a slow response time.
Type the AT Command string to answer a call. Example: ata
Select this check box to have the ZyXEL Device drop the DTR (Data Terminal
Ready) signal after the "AT Command String: Drop" is sent out.
Type the keyword that precedes the CLID (Calling Line Identification) in the AT
response string. This lets the ZyXEL Device capture the CLID in the AT response
string that comes from the WAN device. CLID is required for CLID authentication.
Example: NMBR
Type the keyword preceding the dialed number.
Type the keyword preceding the connection speed. Example: CONNECT
Type a number of seconds for the ZyXEL Device to try to set up an outgoing call
before timing out (stopping). Example: 60
Type a number of times for the ZyXEL Device to retry a busy or no-answer phone
number before blacklisting the number. Example: 0
Chapter 5 WAN Setup