HP 8901B Operation And Calibration Manual page 66

7-2
Diagram
1-1.
Setup for
Learning
Basic Operation
To get ready to learn to use the HP 8901B, connect the HP 8901B, an
HP 11722A Sensor Module, and a signal generator together as shown
in Diagram 1-1.
The HP 8907B If you are unpacking a new HP 8901B you will want to refer to the
installation suggestiqns provided in Appendix A.
The HP 7 1722A The procedures in this guide are written for use with an HP 11722A
Sensor Module. There are many power sensors that can be used
with the HP 8901B as well. If you are using a power sensor
(rather than a Sensor Module), refer to your HP 89018 Operation
and Calibration Manual for information on which power sensors
can be used and how to operate them with the HP 8901B.
The Calibration Data
Once the HP 8901B is up and running, you
will
need
to
first detennine
if the calibration data for the Sensor Module you are using has been
stored in the
HP
8901B. Appendix B contains a procedure for determining
whether the correct calibration data has been entered into the HP 8901B.
(Refer to Appendix B if you are not certain that the calibration data for
the Sensor Module you are using has been entered into the HP 8901B.)