Track Capture And Swap; Capturing A Track - Zoom HD16 Operation Manual

●
Sampling frequency other than 44.1 kHz
A selection screen for choosing whether to perform
conversion to 44.1 kHz (resampling) appears.
BASS.WAV BASS.WAV
Resample On Resample On
Turn the dial to select whether to perform resampling or not,
and press the [ENTER] key. The indication "Import?" appears
on the display. If audio data exist at the import destination, the
indication "Overwrite?" is shown. When the import operation
is performed, these data will be overwritten.
5.
To carry out the import operation, press the
[ENTER] key once more.
When the import operation is completed, the unit returns to the
V-take selection menu.
By pressing the [EXIT] key instead of the [ENTER] key, you
can cancel the operation and back up one step at a time.
NOTE
Imported audio files are always played with a sampling
frequency of 44.1 kHz. If resampling was disabled during the
import process, a file with a different sampling frequency will
play back with a different pitch and tempo.
ZOOM HD8/HD16

Track capture and swap

You can capture the audio data of any track and temporarily
store them on the hard disk. Later you can swap the captured
data with the current data of the track. This lets you save the
state of a track before an editing operation. If the result of the
operation is not as desired, you can then easily restore the track
to its previous state.
◆ Capture
Recorder
Track 1
Track 2
Track 3
Captured
data of
track 1
◆ Swap
Recorder
Track 1
Track 2
Track 3
Captured
data of
track 1
Recorder
Track 1
Track 2
Track 3
Captured
data of
track 1
NOTE
• Capture is performed on a track by track basis.
• Captured track data will be erased from the hard disk when
another project is loaded or when the power is turned off.

Capturing a track

You can capture the audio data of any specified track.
1.
From the main screen, press the [PROJECT/
UTILITY] key.
The indication "REC UTILITY" appears on the first line of the
display, and "PROJECT" is shown on the second line.
2.
Use the cursor left/right keys to bring up the
indication "CAPTURE/SWAP" on the second
line of the display, and press the [ENTER] key.
The display indication changes as follows.
Reference [Track Editing]
Recorded data
Capture operation for track 1
Recorded data
Swap operation for track 1
65