Zoom HD16 Operation Manual page 31

Track1 Track1
EQ HI G=-10dB EQ HI G=-10dB
3.
Repeatedly press the [SELECT] key, until the
parameter to adjust is shown.
The display shows the selected parameter.
Track1 Track1
EQ MID G=0dB EQ MID G=0dB
The [SELECT] key gives access to the following track
parameters.
Parameter Setting range
EQ HI GAIN (*) -12 – +12dB
EQ MID GAIN (*) -12 – +12dB
EQ LOW GAIN (*) -12 – +12dB
CHORUS DELAY
0 – 100
SEND LEVEL (*)
REVERB SEND
0 – 100
LEVEL (*)
SUB-OUT SEND
LEVEL (*) 0 – 100
<< only>>
PAN L100 – R100
Parameters marked with (*) can be switched on and off.
The currently selected track parameter is shown by the lit
parameter select indicator to the left of the display.
ZOOM HD8/HD16
Description
Adjusts high
frequency range boost/
cut.
Adjusts mid frequency
range boost/cut.
Adjusts low frequency
range boost/cut.
Adjusts level of signal
sent from track/input
to chorus/delay effect.
Adjusts level of signal
sent from track/input
to reverb effect.
Adjusts level of signal
sent from track/input
to STEREO SUB-
OUT jack.
Adjusts panning for
the track/input. For
stereo tracks, this
adjusts the left/right
balance.
Track1 Track1
Lit
EQ MID G=0dB EQ MID G=0dB
Parameter select
indicators
4.
Turn the parameter knob for the track whose
parameter value you want to adjust.
The display switches to the track that is being adjusted, and the
value of the track parameter selected in step 2 changes.
Track3 Track3
EQ HI G=-10dB EQ HI G=-10dB
HINT
• To adjust a track parameter for the drum/bass track, press the
[RHYTHM] status key to select the drum track (key lit in green)
or rhythm track (key lit in red), and then operate the knob.
• For stereo tracks, the parameter change applies to both tracks.
For parameters marked with a (*) in the table at left, you can
press the [ENTER] key to switch the parameter on or off for
the most recently adjusted track. For example, if you press the
[ENTER] key while adjusting EQ HIGH GAIN for track 3, the
display changes as follows, and high-frequency EQ for that
track is set to off.
Track3 Track3
EQ HI G=-10dB EQ HI G=-10dB
[ENTER] key
Track3 Track3
EQ HI Off EQ HI Off
HINT
It is also possible to first select a track with the left/right cursor
keys or the status keys and then switch the parameter on or off.
5.
Repeat steps 3 – 4 to adjust other parameters
Quick Tour
Parameter knob 3
31