Hyundai i10 Owner's Manual page 383

4. Adjust the tire inflation pressure to
the recommended tire inflation.
With the ignition switched on, pro-
ceed as follows.
- To increase the inflation pres-
sure : Switch on the compressor.
To check the current inflation
pressure setting, briefly switch off
the compressor.
- To reduce the inflation pres-
sure: Press the button (9) on the
compressor.
NOTICE
Do not let the compressor run for
more than 10 minutes, otherwise
the device will overheat and may
be damaged.
i
Information
The pressure gauge may show higher
than actual reading when the compres-
sor is running. To get an accurate tire
reading, the compressor needs to be
turned off.
CAUTION
If the inflation pressure is not
maintained, drive the vehicle a
second time, refer to Distributing
the sealant. Then repeat steps 1 to
4.
Use of the TMK may be ineffectual
for tire damage larger than approx-
imately 4 mm (0.16 in).
We recommend that you contact
an authorized HYUNDAI dealer if
the tire cannot be made roadwor-
thy with the Tire Mobility Kit.
WARNING
The tire inflation pressure should
meet the standard "TIRES AND
WHEELS" in Chapter 2 or "Tire
Inflation Pressure Standard Label"
on the B pillar of the driver's seat.
If it is not, do not continue driving.
Call for road side service or tow-
ing.
CAUTION
Tire pressure sensor
(if equipped with TPMS)
The sealant on the tire pressure
sensor and wheel should be
removed when you replace the tire
with a new one and inspect the tire
pressure sensors at an authorized
dealer.
i
Information
When reinstalling the repaired or
replaced tire and wheel on the vehicle,
tighten the wheel lug nut to 11~13
kgf·m (79~94 lbf·ft).
07
7-31