Hyundai i10 Owner's Manual page 381

5. Plug the compressor power cord
(4) into the vehicle power outlet.
6. With the ignition switch in the ON
position, switch on the compressor
and let it run for approximately 5~7
minutes to fill the sealant up to
proper pressure. (refer to the Tire
and Wheels, chapter 2). The infla-
tion pressure of the tire after filling
is unimportant and will be checked/
corrected later.
Be careful not to overinflate the tire
and stay away from the tire when
filling it.
Tire pressure
Do not attempt to drive your vehi-
cle if the tire pressure is below 200
kPa (29 psi). This could result in an
accident due to sudden tire failure.
7. Switch off the compressor.
8. Detach the hoses from the sealant
OAC3079013TU
bottle connector and from the tire
valve.
Return the Tire Mobility Kit to its stor-
age location in the vehicle.
Carbon monoxide
Do not leave your vehicle running
in a poorly ventilated area for
extended periods of time. Carbon
monoxide poisoning and suffoca-
tion can occur.
CAUTION
WARNING
07
7-29