Safety Symbols - York MILLENNIUM YCAR0315 Installation Operation & Maintenance

The following symbols are used in this document to alert the reader to areas of potential hazard:
DANGER indicates an imminently
hazardous situation which, if not
avoided, will result in death or seri-
ous injury.
WARNING indicates a potentially haz-
ardous situation which, if not avoided,
could result in death or serious injury.
In complying with YORK's policy for continuous prod-
uct improvement, the information contained in this
document is subject to change without notice. While
YORK makes no commitment to update or provide
current information automatically to the manual owner,
that information, if applicable, can be obtained by con-
tacting the nearest YORK Applied Systems Service
office.
External wiring, unless specified as an optional connection in the manufacturer's product
line, is NOT to be connected inside the micro panel cabinet. Devices such as relays, switches,
transducers and controls may NOT be installed inside the micro panel. NO external wiring
is allowed to be run through the micro panel. All wiring must be in accordance with YORK's
published specifications and must be performed ONLY by qualified YORK personnel. YORK
will not be responsible for damages/problems resulting from improper connections to the
controls or application of improper control signals. Failure to follow this will void the
manufacturer's warranty and cause serious damage to property or injury to persons.
YORK INTERNATIONAL

SAFETY SYMBOLS

CHANGEABILITY OF THIS DOCUMENT
CAUTION identifies a hazard which
could lead to damage to the machine,
damage to other equipment and/or en-
vironmental pollution. Usually an in-
struction will be given, together with
a brief explanation.
NOTE is used to highlight additional
information which may be helpful to
you.
It is the responsibility of operating/service personnel
as to the applicability of these documents to the equip-
ment in question. If there is any question in the mind
of operating/service personnel as to the applicability
of these documents, then, prior to working on the equip-
ment, they should verify with the owner whether the
equipment has been modified and if current literature
is available.
FORM 150.52-NM2 (1001)
7