Areas Of Application - Bosch FCS‑320‑TM Series Operation Manual

8 en | Technical specifications
Plug-and‑play
The plug-and‑play function makes the installation and commissioning of the aspirating smoke
detectors simple. The housing base is preinstalled on site. By preinstalling the detection
module for standard applications, the FCS-320-TM series Aspirating Smoke Detectors are
ready for operation as soon as they are inserted into the housing base.
Patented air sampling openings
The air sampling openings of the pipe system require clearly defined bore diameters that
depend on the planning and design. These precise air sampling openings are created using
patented aspiration reducing film sheets, marking tape, and clips, which not only permit easy
installation, but also prevent "whistling" noises. Another advantage is the quick and easy
detection and checking of the air sampling opening diameters.
Point-type detector projection
The system's aspiration points can be equated with point-type smoke detectors. The
monitoring areas can therefore be planned in accordance with the applicable national
regulations.
Diagnostics
A system with FAS‑ASD‑DIAG Diagnostic Software, which enables quick and convenient error
containment, is available for maintenance and service. The current and stored (max. 72 hours)
unit status is read out to the diagnostic appliance via the unit's infrared port. The data is
transmitted from the diagnostic appliance to a laptop via a USB cable.
Selecting the fan voltage
The fan voltage can be increased from 9 V to 12 V for any special planning processes. In
addition, the fan voltage can be increased up to 13.5 V in intervals of 1 V via the FAS-ASD-
DIAG Diagnostic Software. The increase in the fan voltage causes an increase in the air
transport speed and therefore reduces detection time.
Extensive pipe accessories
The extensive range of accessories enables the FCS-320-TM aspirating smoke detectors to be
used even in the most difficult conditions. Products from air filters and condensate separators
to blowing-out systems increase the service life in extremely dusty, damp and cold
environmental conditions.
3.2

Areas of Application

Thanks to their detection principle, FCS-320-TM aspirating smoke detectors represent an
extremely versatile fire protection solution.
Principle
Air samples are taken from the monitoring range by a pipe system with defined aspiration
borings and then fed to the detection module.
This is especially well-suited for areas in which point-type detectors cannot be used or can
only be used under certain circumstances. These include:
–
–
–
–
–
–
–
–
2020.04 | 2.1 | F.01U.130.928
Areas that are difficult to access, in which point detectors are difficult to install and
maintain
Air-conditioned areas
Areas that require the earliest detection possible
Areas with a height greater than that allowed for point detectors
Areas in which point detectors are not desired for aesthetic reasons
Areas in which strong electromagnetic fields occur
Areas that are exposed to high or low temperatures
Areas with contaminated air that require filter elements
Operation guide
Conventional Aspiration smoke detector
Bosch Sicherheitssysteme GmbH