Fcs-320-Tm-R Leds; Fas-Asd-Diag Diagnostic Software - Bosch FCS‑320‑TM Series Operation Manual

Conventional Aspiration smoke detector
II
III
IV
3.5.4 FCS‑320‑TM‑R LEDs
FCS-320-TM-R Position
I
II
III
IV
V
3.5.5 FAS‑ASD‑DIAG Diagnostic Software
Figure 3.6: Diagnostic software for importing and reading out the device data
The FAS‑ASD‑DIAG Diagnostic Software enables the saved and current statuses of the
FCS-320-TM and error messages to be saved on a PC or laptop.
Data is transmitted to the diagnostic appliance via the infrared port of the aspirating smoke
detector. The USB cable provided is used to transmit the data from the diagnostic appliance
to the PC/laptop (see figure above).
Diagnostic messages remain saved in the FCS-320-TM for at least 3 days in order to be able to
evaluate even short, sporadically occurring errors (e.g. in case of changed operating
conditions). Resetting the FCS-320-TM via the diagnostic software deletes all saved diagnostic
messages. The software also allows the deletion of error messages.
Notice!
The diagnostic software can be used to save in file format all stored and current diagnostics
data and any settings made via the fire panel programming software. To be able to compare
the data read out, save each file under a different file name.
Bosch Sicherheitssysteme GmbH
Main alarm
Malfunction
Infrared port
LED
Operation
Main alarm
Malfunction
Fire source
identification for zones
A-E
Infrared port
DIAG
Operation guide
Technical specifications | en
Red Main alarm
Yellow Malfunction
– in the pipe system
– in the detection module
– caused by fan failure
Fault diagnosis
Color Explanation
Green Operation
Red Main alarm
Yellow Malfunction
– in the pipe system
– in the detection module
– caused by fan failure
5 red LEDs Fire source identification
Fault diagnosis
17
2020.04 | 2.1 | F.01U.130.928